High CPU Load on Cisco 2621 router

Unanswered Question
Apr 12th, 2007

Hi All,

My 2621 router constantly showing 90% CPU load. The show proc cpu command didn't tell me which process used lots of the cpu resources. Can I know whether there is any other way to check it?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3.5 (2 ratings)
Loading.
spremkumar Thu, 04/12/2007 - 23:25

Hi

Can you post the output of show process cpu ?

you can also check out for CEF whether CEF is enabled or not.

once CEF check is over you can enable netflow and find out whether you have worms/virus in your network..

regds

Paolo Bevilacqua Fri, 04/13/2007 - 04:03

In fact the most common cause of high cpu load is abnormal traffic, so spremkumar's answer is correct, didn't deserve low rating so I have rated this to balance.

Actions

This Discussion