LWAPP APs not showing in CiscoWorks

Unanswered Question
Apr 13th, 2007

I recently installed a new WiSM bundle and converted a group of Autonomous APs to LWAPP and now CiscoWorks does not see the APs. Any thoughts on this would be appreciated.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
jakew Fri, 04/13/2007 - 05:54

LWAPP APs don't run SNMP, so CiscoWorks can't talk to them. The informatino CW used to retrieve directly from the APs is now available through the controller. However, I'm not sure CW supports controllers yet.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode