Two ISP link on a single Router

Unanswered Question
Apr 13th, 2007

Hello,

I would like to terminate TWO ISP link on a single router

(ISP-I)----|----router---PIX-----switch

(ISP-II)---|

Please can someone provide a sample configuraiton or cisco link of sample-configuraiton.

Thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
royalblues Fri, 04/13/2007 - 13:16

friend

since these are 2 different ISP's you cannot loadbalance the traffic unless you have your own resitered public address space.

IF this is not the case, then you should configure PBR to loadbalance the traffic. The pix can NAT certain subnets to one ISP address space and the rest to another and Router can use PBR to send the traffic accordingly

HTH, rate if it does

Narayan

asifvanoo Fri, 04/13/2007 - 21:20

I tested PBR but didnt work.

IF you can pass the cisco sample config link for PBR would be helpful.

Thanks

Actions

This Discussion