04-13-2007 12:29 PM - edited 03-11-2019 03:00 AM
HI ALL,
please i want to configure my pix software v7.1 as multiple context , one "admin" and the other "test" context and allocate the ethernet0 nad 1 for the admin context and interface ethernet2 and 3 to test context.
i need configuration.
04-13-2007 04:57 PM
Get stated here:
http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_7_1/conf_gd/contexts.htm
config example:
mode multiple
wr mem
reload
chan context system
admin-context admin
context admin
allocate-interface gigabitethernet 0/0.3
allocate-interface gigabitethernet 0/1.4
config-url disk0://admin.cfg
exit
context cutomersA
description This is the context for customer A
allocate-interface gigabitethernet 0/0.3
allocate-interface gigabitethernet 0/1.5
config-url disk0://contexta.cfg
wr mem
# configure your contexts:
chan cont cutomersA
config example:
http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_7_1/conf_gd/examples.htm
sincerely,
Patrick
09-17-2007 07:54 PM
Hello Patrick,
I'm very very happy, because I found post from you. I have searched in all cisco website and I did not find how to configure a context.
Thank you so much.....
Cassio Gomes
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: