How to tune the ring timout timer in call manager 4.1?

Unanswered Question
Apr 15th, 2007
User Badges:

Hi All,


By default, if user A (IP phone) calls user B (IP Phone), if user B does not answer the call and user A does not change back to on hook, the phone of user B just keep ringing. How to set the timer to cut the call? in CME, just the "timeout" command is needed but I can not find a parameter in CM.


Thanks!


Best Regards,

Teru Lei

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Chris Deren Sun, 04/15/2007 - 07:02
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

The Ring No Answer Duration service parameter should take care of it, this global parameter can be overriten at the line level with the same field.


HTH,


Chris

mchandak Sun, 04/15/2007 - 08:10
User Badges:
  • Gold, 750 points or more

And to add to the suggestion made by Chris, with CM 4.x onwards, you can configure it on individual phones as well and specify how long you want the phone to ring. Each ring is around 4 secs, so if u want the phone to ring for 4 rings, then this timer should be sent to 16

Actions

This Discussion