REAP Mode for AP

Unanswered Question
Apr 16th, 2007

Hi,

May I know if I try to access local resources in my LAN will it travel through the network controller in the remote site?

E.g.:

PC -- Remote AP -- Router -- Router -- Network Controller

Is the web authentication using RADIUS works in REAP case?

Thanks.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (1 ratings)
Loading.
ankbhasi Mon, 04/16/2007 - 08:08

Hi Friend,

If you are talking on AP1000 series then no WEB AUTH will not work as REAP AP always do local switching even when it is in connected status.

IF you have LWAPP converted APs they work as HREAP and WEB auth will work only when it is in connected satus but when it is in standalone status i.e when controller is unreachable state already authenticated clients will keep passing traffic but new clients will not be able to associate.

HTH

Ankur

*Pls rate all helpfull post

wooiboontan Mon, 04/16/2007 - 17:10

Thanks for reply. What about data flow? If I try to access to LAN server and the data will route to remote network controller or just the AP and switch locally?

ankbhasi Mon, 04/16/2007 - 21:44

Hi Friend,

The data will be switched locally by AP and will not hit network controller.

Regards,

Ankur

*Pls rate all helpfull post

bongu Mon, 07/02/2007 - 01:12

if i may make an additional query on this train of thought...

if the data will be switched locally, HREAP...then VPN connections would also be switched locally, correct? referring to the line diagram below, VPN connections will be terminated locally (not get on the LWAPP tunnel)

PC - LAP - FW/VPN Concentrator - L3 cloud - WLC

is there any particular concern on this?

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode