Missing file 5501.img after upgrade radio module

Unanswered Question
Apr 16th, 2007

I have an AP that has been upgraded by someone else. The 802.11g interface does not come up, and an error message "*Mar 1 00:03:15.367: %DOT11-2-NO_FIRMWARE: Interface Dot11Radio0, no radio firm

ware file (flash:/c1200-k9w7-mx.123-8.JEA/5501.img) was found" is seen. Any ideas, I suspect the radio module is not correct for this 1230 AP. I have upgrade IOS to latest version.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
rob.huffman Mon, 04/16/2007 - 05:09

Hi Robert,

I am sure you are on the right track regarding the Radio Module, here is a very similar thread from last December. It seems that the new Radio module (with none of the identifying stickers) may have been intended for the wrong country (A or Japan) Have a look;


Hope this helps! Please let us know your resolution :)


rmcconnell Mon, 04/16/2007 - 18:13

Many thanks,

It would appear that the radio module has been source incorrectly (I suspect not from a cisco partner).

I will have a look at the controller, and post result when I find it.

Many thanks ....Rob


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode