We have 10 Cisco 1200 wireless APs. The VLAN 1 use Windows certificate as authentication and VLAN 100 for the public. They work fine. We just bought two 1310 wireless bridges for outdoor use. We contact Cisco support for setup these two bridges as below:
Building Switch + Cat 5 + Root Bridge ---------- Non-Root Bridge + Switch + cat 5 + PC or wireless in remote site.
The PC in the remote works fine. However, the wireless PC doesn?t work either of public or domain network. It receive the strong signal but the IP or 0.0.0.0 or 169.254.x.x. Any suggestion?
Attached is configuration on non-root bridge.