cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
473
Views
0
Helpful
2
Replies

Problem getting DHCP from AP1131AG repeater

baskervi
Level 1
Level 1

I'm in the process of setting up two APs (new, both running 12.3(8)), one as a root and the other as a repeater. This part has gone without any problems, and the signal strength is good between the two via the linktest.

The problem is that the repeater rarely hands out a DHCP address, although it will occasionally. The host always hands out an IP address. This even happens when all security is disabled.

Thanks for any response.

2 Replies 2

dsweeny
Level 3
Level 3

I have seen such issues too. I would suggest that, you use the parent AP to give DHCP addresses to clients.

Thanks for the suggestion, but there was a bug on the firmware. I just downgraded the IOS, and the system is working now.

Review Cisco Networking products for a $25 gift card