Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
562
Views
0
Helpful
2
Replies

How to setup a Metro Ethernet with two 3560 switch

christfoster
Level 1
Level 1

‎04-17-2007 12:40 PM

I have two locations in various cities that are 32Km apart,and I want to setup a metro ethernet between the two location. I'm assuming my only requirment would be to configure each switch with an Vlan ip address and have the information trunked between the two. Is this a correct assessment? thanks..

Labels:
0 Helpful
2 Replies 2

swaroop.potdar
Level 7
Level 7

‎04-17-2007 03:59 PM

1) If you have a service provider shortlisted who is providing this ethernet circuit between the 2 cities.

2) And if having a single vlan trunked is the requirement then yes.

You just need to configure a vlan and pass it across the service provider uplink trunk.

HTH-Cheers,

Swaroop

0 Helpful

christfoster
Level 1
Level 1
In response to swaroop.potdar

‎04-18-2007 01:52 AM

Thanks for the confirmation....

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents