cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
277
Views
0
Helpful
1
Replies

Use CNA 5.1 to set up EIGRP routing

ricschaaf
Level 1
Level 1

Could anyone describe how to accomplish the attached before and after diagram using CNA 5.1 instead of the CLI?

Steps we have tried are:

- define router ports on both ends using Smartports macros and set native VLAN to default(1)(Should portfast be on or off?)

- assign IP addresses to those interfaces

- turn on routing on both ends and add attached networks in EIGRP tab

???

Thanks

1 Reply 1

ebreniz
Level 6
Level 6

Spanning Tree Protocol (STP) is a Layer 2 protocol that runs on bridges and switches. So you don't need to worry about configuring STP features since you are using ports on the switches as layer 3 routed ports.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco