Configuration of Catalyst 2950 with WLC 2106

Unanswered Question
Apr 17th, 2007
User Badges:

I am current setting up a simple wireless network consist of 2 Aironet 1130 AP,1 WLC 2106 and 1 Catalyst 2950 24 ports.I configured the AP Manager and Management interfaces both on the VLAN 30. at the same time I configured Catalyst 2950 Fa0/6 to be the trunk port connected to the Management port of WLC 2106.which is port 1.and I configure my Fa0/4 as access port for VLAN 30.which i connected it to my laptop.I am able to continously ping to the WLC 2106 management interface IP address from my laptop without fail.the problem appeared when i plug in my 1130 AP to the switch on another port which is configured as VLAN 30. I also connect the AP manager interface port to the catalyst port of VLAN 30. how should i go about it? thanks.


note: the AP should plug to the switch instead to the WLC directly.


any expert can clear my doubt? T.I.A

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ankbhasi Wed, 04/18/2007 - 00:39
User Badges:
  • Cisco Employee,

Hi Friend,


I did not understood your problem? Can you explain again when you said "the problem appeared when i plug in my 1130 AP to the switch on another port which is configured as VLAN 30. I also connect the AP manager interface port to the catalyst port of VLAN 30. how should i go about it?"


You have to map your management as well as ap-manager interface both to port 1 on controller and when you connect your AP on 2950 switch on vlan 30 it will join your controller.


Regards,


Ankur

3iadministrator Wed, 04/18/2007 - 02:04
User Badges:

Hi Ankur,


Yeah, you are right on this.I discovered the same thing as well. my mistake, as I assigned ap-manager to port 2.where it should be on port 1.mistake #2.there is no requirement for physcial connection between ap-manager interface with the switch.


thank for the reply.

best regards

Jack

Actions

This Discussion