VTP

Unanswered Question
Apr 18th, 2007
User Badges:

I have 3 switches 3750?s connected with Cat5 1000mb I need to set up Vlan?s. I?ve tried to set the vtp on one switch as master and the other two as client but when I create a vlan on the master switch I do not see any on the Client switches am I missing something?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ankbhasi Wed, 04/18/2007 - 07:03
User Badges:
  • Cisco Employee,

Hi Friend,


Make sure you configure trunk between switches. Also make sure you have same VTP domain configured on all switches with same password.


I will recommed to first check the trunk connection between switches.


HTH


Ankur

ariela Wed, 04/18/2007 - 22:36
User Badges:
  • Silver, 250 points or more

Hi,


a very basic configuration that you have to do in your switches is like that:


conf t

vtp domain TEST (as you wish, but the same)

vtp mode server|client

vlan x

name X

vlan y

name Y

... (and so on)

interface (between switches)

switchport trunk encapsulation dot1q

switchport mode trunk


So, check your trunk, check your VTP configuration, and that's it.


HTH

Andrea


Actions

This Discussion