Hi,
I am facing a routing issue between an FWSM on a cisco 6509 and a 4506. All routes are being learned by the FWSM via the OUTSIDE interface ((** through a vlan between MSFC and FWSM.The FWSM has adjacency between both the inside 4506 and MSFC through vlans **)).
Now these routes must be passed on to the inside 4506. OSPF is the routing protocol. State of adjacency between FWSM and 4506
is "FULL" on all devices. But still there are no OSPF learned routes on the inside 4506.
FWSM OS is of version 3.1. I have applied an acl for ip any any on inside and outside interface
Thanks and Regards
Sonu.
6500 OSPF config
----------------
router ospf 100
router-id 192.168.31.8
log-adjacency-changes
area 0 authentication message-digest
network 10.73.16.0 0.0.0.255 area 0
network 10.73.34.0 0.0.0.255 area 0
network 192.168.31.8 0.0.0.0 area 0
!
FWSM OSPF config
----------------
router ospf 100
network 10.73.16.48 255.255.255.252 area 0
network 10.73.16.76 255.255.255.252 area 0
network 192.168.31.16 255.255.255.255 area 0
network 192.168.31.0 255.255.255.0 area 0
area 0 authentication message-digest
router-id 10.73.16.49
log-adj-changes
redistribute connected
redistribute static subnets