04-18-2007 09:41 AM - edited 02-21-2020 01:29 AM
Hello All
Any idea what can be causing tunnel interface output drops? All my p-2-p tunnels are reporting output drops.
My remote sites each contain three T1's (PPP Multilink setup) My serial interface;s are not reporting output drops, my Multilink interfaces are reporting perhaps 5% drops compared to the tunnel interface.
Central site contains a DS3 (Carved 18Mbps)
I just cleared the counters and will be monitoring the results.
Thanks
Hank
04-24-2007 08:26 AM
One of the reasons for the increase of dropped packets is that the input rate to the serial interface exceeds the bandwidth available on the serial link
06-04-2007 12:04 PM
06-04-2007 12:05 PM
06-04-2007 12:05 PM
06-04-2007 12:05 PM
06-04-2007 12:05 PM
06-04-2007 12:05 PM
06-09-2007 04:43 PM
Also check your MTU. You could have fragmentation occuring due to 24byte GRE overhead.
06-15-2007 11:05 AM
You are traffic-shaping on the DS3 or are you sending 45Mb to the 18Mb circuit?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide