Applique type is Subrate T3, should be a full T3

Unanswered Question
Apr 18th, 2007

hello

i Have a Cisco 3845 ISR with a NM-1t3 network module installed. When I do a "show controllers t3 1/0" command the Applique type is Subrate. This line is a full 45Mbps. Anyone know why it would be showing Applique type is Subrate.

Many Thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Paolo Bevilacqua Wed, 04/18/2007 - 09:57

Hi,

Applique and subrate are terms derived from other routers hardware, and the code of "show controller" has not been changed since. You can be reassured that your full T3 line is being used as such.

Hope this helps, please rate post if it does

Actions

This Discussion