i Have a Cisco 3845 ISR with a NM-1t3 network module installed. When I do a "show controllers t3 1/0" command the Applique type is Subrate. This line is a full 45Mbps. Anyone know why it would be showing Applique type is Subrate.
Applique and subrate are terms derived from other routers hardware, and the code of "show controller" has not been changed since. You can be reassured that your full T3 line is being used as such.
Hope this helps, please rate post if it does
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
