×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

ignore-dcd opens serial port

Unanswered Question

I have a configuration that requires a serial port to ignore the DCD signal upon startup and have configured it as such with 'ignore-dcd'. The port is SNMP controlled and in the shutdown state at boottime with 'shutdown' command. The issue I have is that the ignore-dcd command is executed after the shutdown command and opens the port when the router is booted up. Any suggestions? Unless I goofed I could not change the order of the two commands.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 2 (1 ratings)
Loading.
paolo bevilacqua Wed, 04/18/2007 - 14:05
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Ouch, sorry, I think if the intention is to boot with the port down ad 'ignore-dcd', and doesn';t work, there is no configuration that would allow that to work.

Actions

This Discussion