04-19-2007 04:14 AM - edited 03-03-2019 04:37 PM
Hello,
Can you please send me a configuration for an E1 PRI , i will use this access for data transfer.
thanks
04-19-2007 04:22 AM
can I use this configuration ?
!
controller E1 1/0
framing NO-CRC4
pri-group timeslots 1-31
!
!
interface Serial1/0:15
ip address 192.168.150.34 255.255.255.224
no cdp enable
encapsulation ppp
dialer idle-timeout 119
dialer string xxxxxx
dialer-group 1
isdn switch-type primary-net5
isdn point-to-point-setup
ppp authentication chap pap callin
ppp chap hostname yyyyyyyy
ppp chap password zzzzzz
!
dialer-list 1 protocol ip permit
04-19-2007 04:24 AM
can use this configuration?
Thnaks
!
controller E1 1/0
framing NO-CRC4
pri-group timeslots 1-31
!
!
interface Serial1/0:15
ip address 192.168.150.34 255.255.255.224
no cdp enable
encapsulation ppp
dialer idle-timeout 119
dialer string xxxxxx
dialer-group 1
isdn switch-type primary-net5
isdn point-to-point-setup
ppp authentication chap pap callin
ppp chap hostname yyyyyyyy
ppp chap password zzzzzz
!
dialer-list 1 protocol ip permit
04-19-2007 04:41 AM
Hi there,
Your configuration basically seems fine, what is the scenario that you are trying to fulfill ?
BR,
Mohammed Mahmoud.
04-19-2007 05:28 AM
I want to use this PRI to backup an access 2Mbps in ser0/0, if it will be down.
what the command isdn point-to-point-setup
mean please?
04-19-2007 10:19 AM
Hi,
If you wanna use it as a backup link, try using with Static Routes with higher Admin Distance or try with Backup Interface.
If you want I may post the configs also.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: