We have just purchased the following.
2811 W/ AC PWR 2FE 4HWICS MS 1NME 2AIMS IP BASE 64
MULTIFLEX TRUNK 26XX/36XX TR
What I need this to do is be setup as a PRI so that multiple customers can communicate with us over ISDN to a FTP server behind this router.
The card is installed in slot 0/0 but nothing is showing up in the config. I have done a few BRI setups before and you always have an interface. I have entered the command
interface E1 0/0
And that adds an interface, but "show interface" does not show any signs of life. My other concern currently is that "debug isdn" does not show up at all. I had hoped that I would slot the card in and the interface would be there, so I am hoping this setup is correct for what I need.
Any help would be great.