cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
338
Views
0
Helpful
2
Replies

Speed & Duplex Switchport Settings

peter.tan
Level 1
Level 1

After setting a switchport to 100 Full Duplex, what IOS command can we use to determine that the laptop client has been set to 100 Full Duplex as well?

2 Replies 2

Collin Clark
VIP Alumni
VIP Alumni

How could IOS determine what the laptop is set too? It can't. Check the NIC proporties to see what it is set at.

jphilope
Level 3
Level 3

You can use the 'SHOW INTERFACE' command to verify the port is not taking errors due to mismatches. But you are not able to see what the host has renegotiated to from the switch.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco