04-20-2007 11:41 AM - edited 03-05-2019 03:35 PM
Hi!
on 4507r,2 sup:sup-wsx4515;i need to configure the RPR Mode;do i need to put the console into sup on slot 2 and configure the redandany mode(rpr) or it is done in the 1st sup on the slot 1 if all config its done form there.
10xs
04-20-2007 12:20 PM
Hi Ali,
This will help you in configuring RPR on 4507R
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_1_12/config/rpr.htm#wp1097801
Supervisor engine redundancy is configured by default when a second supervisor engine is detected
Do read the section "Supervisor Engine Redundancy Guidelines and Restrictions"
HTH
Ankur
04-21-2007 01:02 AM
Hi Ankur!
Thanks a lot for ur reply.
Ali
04-20-2007 12:34 PM
ali,
take a look at this:http://www.cisco.com/univercd/cc/td/doc/product/ong/15400/r46docs/r46mlios/rpr.htm
regards
Devang
04-20-2007 12:55 PM
Hi Devang,
Long time!! How are you!!
I believe what Ali is looking for is RPR operation betwen 2 supervisor engines which is route processor redundancy.
Regards,
Ankur
04-21-2007 01:04 AM
Hello Devang!
Welcome Back;long Time Ya man;where have you been?
Ali
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide