RPR

alsayed · ‎04-20-2007

Hi!

on 4507r,2 sup:sup-wsx4515;i need to configure the RPR Mode;do i need to put the console into sup on slot 2 and configure the redandany mode(rpr) or it is done in the 1st sup on the slot 1 if all config its done form there.

10xs

ankbhasi · ‎04-20-2007

Hi Ali,

This will help you in configuring RPR on 4507R

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_1_12/config/rpr.htm#wp1097801

Supervisor engine redundancy is configured by default when a second supervisor engine is detected

Do read the section "Supervisor Engine Redundancy Guidelines and Restrictions"

HTH

Ankur

alsayed · ‎04-21-2007

Hi Ankur!

Thanks a lot for ur reply.

Ali

devang_etcom · ‎04-20-2007

ali,

take a look at this:http://www.cisco.com/univercd/cc/td/doc/product/ong/15400/r46docs/r46mlios/rpr.htm

regards

Devang

ankbhasi · ‎04-20-2007

Hi Devang,

Long time!! How are you!!

I believe what Ali is looking for is RPR operation betwen 2 supervisor engines which is route processor redundancy.

Regards,

Ankur

alsayed · ‎04-21-2007

Hello Devang!

Welcome Back;long Time Ya man;where have you been?

Ali