New vwic2 mft2 t1/e1 in MGCP 2851 not recognized when installed

Unanswered Question
Apr 20th, 2007
User Badges:

We have a 2851 running c2800nm-spservicesk9-mz.124-11.T1.bin with two existing VWIC-2MFT-T1-DI= cards that were operational with 2 existing 48 channel pvdm2 modules. We added a 3rd 48 channel pvdm2 module and 1 vwic2-2mft-e1/t1 and the router doesn't see the card in the controller t1 0/2/0. we tried configuring the settings in the CM for the new PRI card and watched on console as the configed commands pushed from the CM failed. Can someone please advise as this gateway is no longer registered and we are impaired with the loss of the previously working 2 T1 PRI's.



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
paolo bevilacqua Sat, 04/21/2007 - 03:08
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member


probably youve done that already, but please configure card type T1 in order for the controller to be configured.

Hope this helps, If so please rate post!


This Discussion