04-20-2007 06:44 PM - edited 03-03-2019 04:39 PM
We have a 2851 running c2800nm-spservicesk9-mz.124-11.T1.bin with two existing VWIC-2MFT-T1-DI= cards that were operational with 2 existing 48 channel pvdm2 modules. We added a 3rd 48 channel pvdm2 module and 1 vwic2-2mft-e1/t1 and the router doesn't see the card in the controller t1 0/2/0. we tried configuring the settings in the CM for the new PRI card and watched on console as the configed commands pushed from the CM failed. Can someone please advise as this gateway is no longer registered and we are impaired with the loss of the previously working 2 T1 PRI's.
Thanks,
-Scott
04-21-2007 03:08 AM
Hi,
probably youve done that already, but please configure card type T1
Hope this helps, If so please rate post!
04-21-2007 11:28 AM
As paulo suggested, the second generation WIC cards require the card type command
have a look at this
HTH, rate if it does
Narayan
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: