ISP DHCP to Static ip.

Unanswered Question


I have problems with PAT translation to a inside server. Somebody tell my that i can`t use a dynamic DHCP of the ISP to use the NAT/PAT transalation. If i configure a static ip-adres on the BVI interface then en can`t ping the ISP gateway. Is it possible to configure this a staic ip with ISP DHCP? Is is possible to use Dynamic ip for NAT/PAT?

I hope somebody can helping.




I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Paolo Bevilacqua Thu, 04/26/2007 - 11:57


please configure:

int eth0

no hold-queue 100 out

int atm0

no bridge group 1

no pvc 0/34

int atm0.1 point-to-point

bridge-group 1

pvc 0/34

encapsulation aal5snap

int bvi1

no ip access-list 100 in

no ip route

That should make things work.

I'm astonished about the other answer about an old series 700 non-ios router, now dead since almost 10 yers!!!

Hope this help. Please rate all useful posts using the scrollbox below!


This Discussion