CSAdmin service has failed on the Backup ACS

Unanswered Question
Apr 22nd, 2007


I have imaged on an ACS solution engine and everything was going fine and I made it as a secondary ACS and managed to replicate the entire database from the primary. When I shifted the ACS from one place of the network to another (but on the same vlan), I shut it down and switched on again. The CSAdmin has stopped after that and I could not access the Unit through WebUI anymore. I'm trying to turn on the service manually but it does not come up. plus the Command lines are moving very slowly... it looks the CPU utilization is 100% even though there is nothing connected except my laptop back to back on one interface...

What is causing this problem and how to solve it??

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
pradeepde Fri, 04/27/2007 - 05:20

System resource consumption by Cisco Secure ACS?CSMon periodically monitors and records the usage by Cisco Secure ACS of a small set of key system resources. Handles counts, memory utilization, processor utilization, thread used, and failed log-on attempts, and compares these to predetermined thresholds for indications of atypical behavior.

mark.cronin Wed, 05/09/2007 - 00:20

Can you let me know what the Cisco TAC engineer did. I have the same problem

oabduo983 Wed, 05/09/2007 - 06:10

They posted a patch which was available for three days and I used and fixed the issue!

mark.cronin Wed, 05/09/2007 - 07:31

have you got a TAC case number for this

I am going to raise a call with Cisco


This Discussion