Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
2449
Views
0
Helpful
1
Replies

Error disable snmp traps

avillalva
Level 1
Level 1

‎04-22-2007 05:44 PM - edited ‎03-05-2019 03:36 PM

Hi all,

I want to enable a 3550 IOS ver 12.1 to send a trap if any ports go into err disable state.

is the: "snmp-server enable traps port-security" the command I am looking for? Is there anything more granular (i.e. it sends traps only if a port is in err-disable).

Thanks in advance,

Andres

Labels:
0 Helpful
1 Reply 1

carenas123
Level 5
Level 5

‎05-02-2007 05:13 AM

To enable SNMP notifications (traps or informs), use the snmp-server enable traps command. To disable all SNMP notifications, use the no form of this command.

snmp-server enable traps [flash [insertion | removal] | fru-ctrl |

port-security[ trap-rate trap-rate] | removal | stpx | vlancreate | vlandelete | vtp]

no snmp-server enable traps flash [insertion | removal] | fru-ctrl |

port-security[ trap-rate trap-rate] | removal | stpx | vlancreate | vlandelete | vtp]

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card