04-24-2007 01:43 AM - edited 03-14-2019 12:47 AM
How do you trigger a ROUTING Script without calling a number. I dont want to use an Administrative script.
I want the Routing Script to be triggered automatically lets say once in an hour.
I have unity and CCm 4.0
any idea?
04-25-2007 07:37 AM
You cannot do this with routing scripts - they must be triggered by a real (phone) call.
There is a workaround, perhaps you can configure a neat IVR script that would call 101 (which is mapped to the routing script in ICM), which is triggered by calling 102, which is triggered by JTAPI, perhaps.
04-26-2007 12:14 PM
You could consider upgrading the 5-seat standard IPCC license that comes with CCM4.0 to enhanced, then write an http triggered script and have a webpage call the http trigger and ave a refreshtime of x seconds. That way it would triger the script every x seconds, and depending on what is in the script you would be able to set up a call.
I don?t think there is any solution with your current unity and ccm4.0
HTH,
Leo
04-26-2007 01:19 PM
It s IPCC Enterprise 6.0 we are using.
04-27-2007 12:12 AM
One simple question: Why don't you want to use an Administrative Script?
If you have IP/IVR in your deployment, you can try to set up an HTTP enabled script that is launched by a servlet, IP/IVR runs the script associated to the HTTP trigger and this scripts initiate a call to a CTI Route Point associated to the ICM DN that is associated to the routing script. This is very similar to the 'netbakter' post.
Regards,
Juan Luis
04-27-2007 12:59 AM
I tell you why:
Im writing a script which permanently (once in an hour) check if the IVRs are online, if not i want to get an Alert, which is in my case the Label in the script where i will put my cell phone number.
With administrative script you cant use label, you would just put variables. this variable i check in my routing scripts. Here is what i do:
Administrative Script:
If:
(Peripheral.VRU1.Online==1)&&(Peripheral.VRU1.Mode==1)
then:
set global variable to 1
on the Routing script:
if global variable=1 -> Label=My Cell Phone.
The script works fine, but i always need to dial the CTI-RP. I want this to be done automatically.
Its a newbie script i know. would appreciate any suggestion.
04-27-2007 01:13 AM
Hi,
You can try to devolop an application based on 'Application Gateway' ICM feature in this way:
When your admiinstrative script detects that the one VRU are offline, this script communicates through the Application Gateway with an application, very basic, that can initiate a call to your CTI Route Point (you can use CTIOS for that).
It is only an idea.
Hope this helps,
Juan Luis
08-14-2007 03:13 AM
Hi,
You can try the outbound option for this. You can run a campaign that will dial your number based on a variable on the admin scripts.
I did not do it, but just a thought.
Best Regards,
Fadi
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide