04-24-2007 06:36 AM - edited 03-05-2019 03:39 PM
Hi Netpro's,
I have a 6506 sup1a with ws-x6348-rj45 module. how can i verify whether it is 'PoE' ready? Any valuable inputs appreciated.
TIA
Faiz
Solved! Go to Solution.
04-25-2007 12:25 AM
Faiz,
Yes you can field upgrade the module to a Cisco Prestandard POE daughter card not the IEEE 802.3af standard. The part number you need is WS-F6K-VPWR=.
Here is the link which confirms the same:
http://www.cisco.com/en/US/products/hw/switches/ps708/products_data_sheet0900aecd8017376e.html
HTH,Please rate if it does.
-amit singh
04-24-2007 06:41 AM
Hi Faiz,
If it is CATOS then issue a command "show environment power
But if your card model number is ws-x6348-rj45 I do not think it supports inline power but if it is WS-X6348-RJ-45V then it does support inline power.
HTH
Ankur
*Pls rate helpfull post
04-25-2007 12:01 AM
Thanks Ankur,
I think u r right, this module does not support Inline Power. I have read somewhere that in order to upgrade this module it has to install a daughter card to enable this PoE feature, I am not sure but. If its true then please let me know any documentation supporting this upgrade feature.
TIA
Faiz
04-25-2007 12:25 AM
Faiz,
Yes you can field upgrade the module to a Cisco Prestandard POE daughter card not the IEEE 802.3af standard. The part number you need is WS-F6K-VPWR=.
Here is the link which confirms the same:
http://www.cisco.com/en/US/products/hw/switches/ps708/products_data_sheet0900aecd8017376e.html
HTH,Please rate if it does.
-amit singh
04-25-2007 12:33 AM
Thanks Amit.
Lemme see how it goes.
Faiz
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: