stacking

hubert456 · ‎04-24-2007

i would like to add an addition switch

3750G 48PS to a production stack which is having 3750 ( not 3750G). what do i need to be prepare?

thanks

desai.jaideep · ‎04-24-2007

Hi

The good thing about stacking is that your operations wont affect.

Just make sure that while connecting the new switch to the existing stack using the stacking cable, you do not pull both the port's cable. Let one be there. This will continue the operation flow.

After you have introduced the new member, everything will be back to normal as it were.

Here are the following links which can help you

http://www.cisco.com/en/US/products/hw/switches/ps5023/products_installation_guide_book09186a00807c64d9.html

Regards

JD

Amit Singh · ‎04-24-2007

Hello,

There are few things to be considered when you connect a new switch to a running stack. Please see the link below for managing switch stacks on 3750:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12235se/scg/swstack.htm#wp1189523

HTH,Please rate if it does.

-amit singh

hubert456 · ‎04-24-2007

does the new switch 3750G will take the master role of the 3750 Stack? because it has the higher speed port.

mohammedmahmoud · ‎04-24-2007

Hi there,

No it shouldn't, take a look on this list:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12235se/scg/swstack.htm#wp1152806

HTH,

Mohammed Mahmoud.

hubert456 · ‎04-25-2007

thank you very much .... Mahmoud