I placed Cisco 1841 router at remote site and i forgot to remove the access class 23 which permits telnet sessions only from 10.10.10.0 0.0.0.7 by default.
Can i access the router remotly by anyway or i need to visit that site ? :(
No PCs installed with the router LAN
thanks in advance
I think its doable, configure a loopback with an ip in that range 10.10.10.0/29 (and insure appropriate routing for this ip to reach your router, hoping that your router has a default route or something pointing it back), and use this command:
telnet /source-interface loopback x
HTH, please rate if it does,