POLICY BASED ROUTING HELP NEEDED

Unanswered Question
Apr 25th, 2007

I have an 1841 router with two internet connections. One adsl & the other 2meg leased line.

On the Inside of the 1841 is an ISA server with a 10.1.1.1 address

Recently I configured POLICY BASED ROUTING so that Remote access users connect through to the

ISA server through the leased line. The ISA's 10.1.1.1 is then natted to 194.XXX to go through the leased line

ALL other traffic from the ISA is routed through the ADSL interface. This time the ISA 10.1.1.1 nats to 217.XXX

There is also an OUTGOING PAT for internet traffic which nats ALL the 10.1.1.0 255.255.255.0 traffic against the ADSL interface of the router.

We are now trying to invoke POLICY BASED ROUTING for a SITE TO SITE IPSEC vpn.

I BELEIVE I HAVE CONFIGURED PBR TO ROUTE AND NAT DOWN THE LEASED LINE INTERFACE

However when I look at the output of IP nat translations I only see a nat for the ISA against the ADSL interface & not tHE LEASED LINE INTERFACE from this config can anyone see why?

Attachment: 
I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
jbayuka Wed, 05/02/2007 - 05:26

Using the route ip route 0.0.0.0 0.0.0.0 Dialer0 at the beginning is the problem.So all the routes gets matched to dialer 0 interface.So have it after ip route 87.246.76.147 255.255.255.255 FastEthernet0/1.

Actions

This Discussion