Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
297
Views
0
Helpful
2
Replies

1841 Config

ihost_tim
Level 1
Level 1

‎04-25-2007 11:15 AM - edited ‎03-05-2019 03:41 PM

I'm not sure if this is the right place to post, but I can't seen to find the answer after several hours of searching online.

I'm working with an 1841 router with 2 ethernet ports. What I want to do is to set them to foward packets back and forth. This has to be bi-directional, so a gateway of last resort will probably not be feasible.

Any suggestions or hints about how to configure this?

Labels:
0 Helpful
2 Replies 2

spremkumar
Level 9
Level 9

‎04-29-2007 08:31 PM

Hi

You need to have proper routing defined on the router so that the traffic can move to and fro.

regds

0 Helpful

Martin Parry
Level 3
Level 3

‎05-10-2007 08:17 AM

By default the router will route between the directly connected subnets, as it knows how to get to them both.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card