No,

I found a document for password recovery.

http://www.cisco.com/en/US/products/hw/contnetw/ps792/prod_password_recoveries_list.html

But then i realize that for more reboots i perform, it is always appearing a menu for configuration. Is this all about menus???

Tks,

Petr?nio

Hi,

I perform the password recovery, as it was documented and then its always getting the "CSS 11501 Offline Diagnostic Monitor menu (OffDM)" Menu, even if i dont press the Y key in the bootup question "Would you like to access the Offline Diagnostic Monitor? (Y)"

Any ideias?

How can i test the login i changed before?

Here is the bootup logging that appear's.

I'm not pressing any key.

******** Boot UP ********

CSS 11501 Offline Diagnostic Monitor menu (OffDM)

Version: 08.10.1.06

M A I N M E N U

Enter the number of a menu selection:

1* Set Boot Configuration

2. Show Boot Configuration

3* Advanced Options

4. Reboot System

> 4

Are you sure you want to reboot? (y/n) [n] y

Rebooting....

BootRom...booting

Copyright (1998-2002), Cisco Systems, Inc

Locked boot flash.

Validating operational boot flash, please wait...

Operational boot flash valid. Jumping to operational boot flash.

Copyright (1998-2002), Cisco Systems, Inc

Operational boot flash.

Attaching interrupt handlers...Done.

Built Mar 9 2006 @ 17:56:32

Version 08.10.1.06

Press to enter the Diagnostic Monitor

* * * * * * * * * * * * * * * * * * * * * * * *

Ran 1 times, 24 tests. Detected 0 errors.

Booting OffDm @ 0xbff00000

SCM:MASTER Other:NOT-PRESENT

Initializing the disk...OK

Reading configuration records...

No Primary or Secondary Boot Record Found

FAILED

MGMT disabled, network port not active

Would you like to access the Offline Diagnostic Monitor? (Y)

Booting(-) ...

Transferring to menu...

Waiting for commands..

CSS 11501 Offline Diagnostic Monitor menu (OffDM)

Version: 08.10.1.06

M A I N M E N U

Enter the number of a menu selection:

1* Set Boot Configuration

2. Show Boot Configuration

3* Advanced Options

4. Reboot System

>

Hi,

I guess this is the problem:

....

"No Primary or Secondary Boot Record Found

FAILED"

....

I'm not sure about procedure, but try to find info about setting Boot configuration!

I guess you should use options 2. and 1. from the meny...

But first read some docs carefully!

Regards,

Jasmina

2. When you power up the CSS on a routine basis, the boot process:

?Displays the software version and build number

?Performs hardware initialization and power-on self tests

?Provides access to the Offline DM menu

?Prompts you to log in to the CSS

It's all happening, except for the last line.

It doesn't prompt for login, cause it goes enter the Offline DM Menu automaticaly.

Tks,

Petr?nio

Hi,

Can you show what the setup is in the OffDM for the boot. In other words, actually go into the "set boot" part of the Offline DM and make sure it is set to boot off of the correct code if any. Also make sure the PCMCIA card is in the CSS correctly as this is what the CSS is booting off of.

Regards

Pete..