vlan problem

Unanswered Question
Apr 26th, 2007
User Badges:

I have connected a router to a switch with all the necessary configurations enabled. The ethernet port has no physical ip add only the subinterfaces has an ip add with different subnet masks with encap dot1q with its corresponding vlan no. specified. However, when i check the subinterfaces they are both physically up but protocol down (layer 2) and only the main interface is up on both layer 1 and 2. Checking the switch, the ethernet port connected to the router is also down on layers 1 and 2. I have made sure that trunking has been enabled on the switchport connected to the router and that both connected ports have the same encapsulation (dot1q).

I would appreciate any help regarding this. Thank you.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
sundar.palaniappan Thu, 04/26/2007 - 12:25
User Badges:
  • Green, 3000 points or more

What kind of router is this. Does it have an etherswitch card in it? If it does then you need to create the VLANs in the router. Posting the configuration would help.


HTH


Sundar



Actions

This Discussion