Offnet to Offnet Transfer

Unanswered Question
Apr 26th, 2007

Hi All,

I have got a problem on CCM4.2 where the Offnet to Offnet transfer wont't work. I have checked the service parameter to make sure it is allowed. External party A calls in. I press transfer then dial another external party B. I can announce the call to external party B. As soon as i press transfer to connect the 2 partys. Both calls get disconnected. Is it possible that there is something on the gateway that has to be done to allow this. It is happening on 2 differtent sites. 1 is PRI and the other BRI.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
csco10968068 Thu, 04/26/2007 - 20:01

Hi Thisisshanky,

Following is the bebug.

*Apr 27 13:47:11.212: ISDN Se0/0/0:15 Q931: RX <- SETUP pd = 8 callref = 0x00CC

Sending Complete

Bearer Capability i = 0x8090A3

Standard = CCITT

Transfer Capability = Speech

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0xA18388

Preferred, Channel 8

Progress Ind i = 0x8083 - Origination address is non-ISDN

Calling Party Number i = 0x2181, '738401218'

Plan:ISDN, Type:National

Called Party Number i = 0xC1, '30104203'

Plan:ISDN, Type:Subscriber(local)

High Layer Compat i = 0x9181

*Apr 27 13:47:11.228: ISDN Se0/0/0:15 Q931: TX -> CALL_PROC pd = 8 callref = 0x80CC

Channel ID i = 0xA98388

Exclusive, Channel 8

xtreamdemortr1#

*Apr 27 13:47:11.400: ISDN Se0/0/0:15 Q931: TX -> ALERTING pd = 8 callref = 0x80CC

*Apr 27 13:47:12.156: ISDN Se0/0/0:15 Q931: TX -> CONNECT pd = 8 callref = 0x80CC

*Apr 27 13:47:12.192: ISDN Se0/0/0:15 Q931: RX <- CONNECT_ACK pd = 8 callref = 0x00CC

xtreamdemortr1#

*Apr 27 13:47:12.192: %ISDN-6-CONNECT: Interface Serial0/0/0:7 is now connected to 738401218 N/A

xtreamdemortr1#

*Apr 27 13:48:18.924: ISDN Se0/0/0:15 Q931: Applying typeplan for sw-type 0x12 is 0x0 0x0, Calling num 3103

*Apr 27 13:48:18.928: ISDN Se0/0/0:15 Q931: Applying typeplan for sw-type 0x12 is 0x0 0x0, Called num 38401285

*Apr 27 13:48:18.928: ISDN Se0/0/0:15 Q931: TX -> SETUP pd = 8 callref = 0x023A

Bearer Capability i = 0x8090A3

Standard = CCITT

Transfer Capability = Speech

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0xA9838A

Exclusive, Channel 10

Calling Party Number i = 0x0081, '3103'

Plan:Unknown, Type:Unknown

Called Party Number i = 0x80, '38401285'

Plan:Unknown, Type:Unknown

xtreamdemortr1#

*Apr 27 13:48:19.116: ISDN Se0/0/0:15 Q931: RX <- CALL_PROC pd = 8 callref = 0x823A

Channel ID i = 0xA9838A

Exclusive, Channel 10

*Apr 27 13:48:19.480: ISDN Se0/0/0:15 Q931: RX <- ALERTING pd = 8 callref = 0x823A

Progress Ind i = 0x8082 - Destination address is non-ISDN

Progress Ind i = 0x8488 - In-band info or appropriate now available

xtreamdemortr1#

*Apr 27 13:48:23.384: ISDN Se0/0/0:15 Q931: RX <- CONNECT pd = 8 callref = 0x823A

Progress Ind i = 0x8082 - Destination address is non-ISDN

Date/Time i = 0x07041B0D38

*Apr 27 13:48:23.388: %ISDN-6-CONNECT: Interface Serial0/0/0:9 is now connected to 38401285 N/A

xtreamdemortr1#

*Apr 27 13:48:23.388: ISDN Se0/0/0:15 Q931: TX -> CONNECT_ACK pd = 8 callref = 0x023A

xtreamdemortr1#

*Apr 27 13:48:32.784: %ISDN-6-DISCONNECT: Interface Serial0/0/0:9 disconnected from 38401285 , call lasted 9 seconds

*Apr 27 13:48:32.784: ISDN Se0/0/0:15 Q931: TX -> DISCONNECT pd = 8 callref = 0x023A

Cause i = 0x80C1 - Bearer capability not implemented

*Apr 27 13:48:32.792: %ISDN-6-DISCONNECT: Interface Serial0/0/0:7 disconnected from 738401218 , call lasted 80 seconds

xtreamdemortr1#

*Apr 27 13:48:32.792: ISDN Se0/0/0:15 Q931: TX -> DISCONNECT pd = 8 callref = 0x80CC

Cause i = 0x80C1 - Bearer capability not implemented

*Apr 27 13:48:32.856: ISDN Se0/0/0:15 Q931: RX <- RELEASE pd = 8 callref = 0x823A

*Apr 27 13:48:32.856: ISDN Se0/0/0:15 Q931: TX -> RELEASE_COMP pd = 8 callref = 0x023A

*Apr 27 13:48:32.896: ISDN Se0/0/0:15 Q931: RX <- RELEASE pd = 8 callref = 0x00CC

*Apr 27 13:48:32.896: ISDN Se0/0/0:15 Q931: TX -> RELEASE_COMP pd = 8 callref = 0x80CC

xtreamdemortr1#

xtreamdemortr1#

Attachment: 
mparekh Wed, 11/07/2007 - 09:37

Any updates to this i am getting similar message in UK

Actions

This Discussion