04-26-2007 10:26 PM - edited 03-10-2019 03:07 PM
Hi NetPro,
basically, i want to create a new group which mainly for 1st support, which mean i want them only allow to use " show command " into my cisco access switch. how do i make it ?
your reply will be highly appreciated.
thanks.
JAckal
Solved! Go to Solution.
04-27-2007 03:59 AM
check out this attachment which might help and was posted in the same forum.
HTH, rate if it does
Narayan
04-27-2007 01:09 AM
Configure command authorisation either as shell commands sets or by per user or by group
04-27-2007 03:59 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide