04-27-2007 12:59 AM
Hi all,
how do we give only interface level config command access and show commands for usergroup.
Thanks in advance.
Rgds,
Rajesh
05-03-2007 11:26 AM
TACACS+ Settings section permits you to enable and configure the service/protocol parameters to be applied for the authorization of a user.For more informartion
http://www.cisco.com/en/US/products/sw/secursw/ps5338/products_user_guide_chapter09186a0080204d46.html#wp595758
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community