CAS channel order

Unanswered Question
Apr 27th, 2007

We know we can use this command to change the order for PRI outbound call

"isdn bchan-number-order"

But is there any command for Cas? Thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (2 ratings)
Paolo Bevilacqua Fri, 04/27/2007 - 07:50

You can define the order that you want on CAS.

Suppose you create one ds0-group per timeslot, that will create 24 voice-ports for T1.

These 24 voice-ports you will re-group together in a trunk-group, each one with a preference that will ultimately define the order in which they are used, or other schemes if you want.

Then the DP will reference the single trunkgroup above.

Hope this helps, please rate post if it does!

ciscoforum Fri, 04/27/2007 - 09:22


Here is the followup question.

1.How can we re-group them in one trunk-group in H323 router?( My scenario does not have CCM). Just PBX-GW----IP-----GW-PBX

2.You know what's the default order on CAS if only group for the channels?

Paolo Bevilacqua Fri, 04/27/2007 - 11:15

[approximate config follows]

controller t1 1/0

ds0-group 1 timeslots 1 type e&m-wink

ds0-group 2 timeslots 2 type e&m-wink

ds0-group 3 timeslots 3 type e&m-wink


voice-port 1/0:1

trunk-group pbx 1

voice-port 1/0:2

trunk-group pbx 2

voice-port 1/0:3

trunk-group pbx 3


trunk group pbx

hunt-scheme sequential

dial-peer voice 10 pots

destination-pattern 4...

incoming called-number 3...


trunkgroup pbx

As a courtesy to those providing answers, please rate all useful posts!


This Discussion