04-27-2007 07:26 AM - edited 03-14-2019 09:12 PM
We know we can use this command to change the order for PRI outbound call
"isdn bchan-number-order"
But is there any command for Cas? Thanks
04-27-2007 07:50 AM
You can define the order that you want on CAS.
Suppose you create one ds0-group per timeslot, that will create 24 voice-ports for T1.
These 24 voice-ports you will re-group together in a trunk-group, each one with a preference that will ultimately define the order in which they are used, or other schemes if you want.
Then the DP will reference the single trunkgroup above.
Hope this helps, please rate post if it does!
04-27-2007 09:22 AM
Thanks.
Here is the followup question.
1.How can we re-group them in one trunk-group in H323 router?( My scenario does not have CCM). Just PBX-GW----IP-----GW-PBX
2.You know what's the default order on CAS if only group for the channels?
04-27-2007 11:15 AM
[approximate config follows]
controller t1 1/0
ds0-group 1 timeslots 1 type e&m-wink
ds0-group 2 timeslots 2 type e&m-wink
ds0-group 3 timeslots 3 type e&m-wink
...
voice-port 1/0:1
trunk-group pbx 1
voice-port 1/0:2
trunk-group pbx 2
voice-port 1/0:3
trunk-group pbx 3
...
trunk group pbx
hunt-scheme sequential
dial-peer voice 10 pots
destination-pattern 4...
incoming called-number 3...
direct-inward-dial
trunkgroup pbx
As a courtesy to those providing answers, please rate all useful posts!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide