WCS AP Setting - Antenna Mode - What does it do?

Unanswered Question
Apr 27th, 2007

Hello,

I'm working configuring our wireless networking. When setting up AP templates in WCS I came across a setting that I'm not sure of and haven't been able to find anything about.

What is Antenna Mode and what does it do? There are three options that I've seen..

Sector A

Sector B

OMNI (Sector A and Sector B)

Does anyone know what these settings do?

Thank You!

Eric

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
scottmac Fri, 04/27/2007 - 08:50

Sector A = "Front"

Sector B = "Rear"

Omni = Front + Rear radiation pattern

Good Luck

Scott

ecornwell Wed, 05/02/2007 - 04:46

I'm guessing that by default they are going to be set to Omni correct? Or is this something I should push through the AP Template?

Actions

This Discussion