Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
933
Views
0
Helpful
4
Replies

WCS AP Setting - Antenna Mode - What does it do?

ecornwell
Level 2
Level 2

‎04-27-2007 07:28 AM - edited ‎07-03-2021 01:59 PM

Hello,

I'm working configuring our wireless networking. When setting up AP templates in WCS I came across a setting that I'm not sure of and haven't been able to find anything about.

What is Antenna Mode and what does it do? There are three options that I've seen..

Sector A

Sector B

OMNI (Sector A and Sector B)

Does anyone know what these settings do?

Thank You!

Eric

Labels:
0 Helpful
4 Replies 4

scottmac
Level 10
Level 10

‎04-27-2007 08:50 AM

Sector A = "Front"

Sector B = "Rear"

Omni = Front + Rear radiation pattern

Good Luck

Scott

0 Helpful

ecornwell
Level 2
Level 2
In response to scottmac

‎05-02-2007 04:46 AM

I'm guessing that by default they are going to be set to Omni correct? Or is this something I should push through the AP Template?

0 Helpful

scottmac
Level 10
Level 10
In response to ecornwell

‎05-02-2007 09:14 AM

I believe Omni is the default.

Good Luck

Scott

0 Helpful

ecornwell
Level 2
Level 2
In response to scottmac

‎05-02-2007 09:58 AM

Thanks for the info!

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card