i have an ASA5520 with v 7.2(2) running.
but the IPS module spftware is 5.1
when i tried to login to the > session 1
it prompts me for a login and password.
i tried cisco and a few other combinations.. but no luck ,,
how do i reset it ?? also that reset procedure on the docs says its resets password or the user cisco ..
how can i be sure if the user cisco even exists on it or not ?
any help please ???
The only way to get the software for your module is downloading it via the Software Center from Cisco.com. You'll need a Smartnet contract or proper CCO account to access the downloads.
You will be able to reimage the module with 6.0 software, but it is advised to reimage it with the most basic image. You can always upgrade from there!
Information about reimaging can be found in the following document:
Hope this information helps, if it does; please rate!