Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
381
Views
0
Helpful
1
Replies

CME 40 call transfer isdn to isdn: how to configure it

MATTHIAS SCHAERER
Level 3
Level 3

‎04-28-2007 07:31 AM - edited ‎03-18-2019 07:15 PM

I have a single 2611XM with two BRI interfaces. I want to be able to transfer external calls back to ISDN (hairpin). All my configuration attempts have failed so far. I always get a fast busy signal after dialing the last digit of the external number.

I have set a transfer-pattern .T, another equaling my external number. I have tried all transfer system types, no sucess at all.

when debugging dialpeers I do not see any output while typing in the transfer number, the same result with debug voice ccapi inout.

I am using CUE 4.0 (12.4(11)T).

Any hint is appreciated.

Labels:
0 Helpful
1 Reply 1

guilhem.perez
Level 4
Level 4

‎05-30-2007 04:06 AM

Hi,

I meet the same issue as you (not able to transfer an isdn call to isdn with cme 4.1).

Have you solved your problem?

Thanks

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents