Solved: C4506 int gig port speed nonegotiate

rkcontrol · ‎04-28-2007

Hi all,

I have a C4506 with gig int, that is showing me speed nonegotiate, I need to remove this config from the gig int, but the IOS shows no other option then nonegotiate. how can i achinve this.

C4506-01#sh run

interface GigabitEthernet3/6

speed nonegotiate

Thanks,

Raj

balajitvk · ‎04-29-2007

Hi RK,

For fiber Gigabit Ethernet interfaces, the default is "no speed nonegotiate", which sets the speed to 1000 Mbps and enables link negotiation for flow-control parameters and remote fault information. The "speed nonegotiate" command disables link negotiation.

So if you want negotiation, it is as simple as other commands,

"no speed nonegotiate" command.

http://www.cisco.com/en/US/products/ps6845/products_configuration_guide_chapter09186a00806e9f38.html#wp1040549

Rate if it does,

Rgs

View solution in original post

ankbhasi · ‎04-29-2007

Hi Raj,

That's the only syntax available for gigabit ethernet interface.

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_1_20/cmdref/snmp_vtp.htm#wp1022290

HTH

Ankur

*Pls rate all helpfull post

rkcontrol · ‎04-29-2007

Thanks,

It worked with the No SPEED command.

RgdsRaj

balajitvk · ‎04-29-2007

Hi RK,

For fiber Gigabit Ethernet interfaces, the default is "no speed nonegotiate", which sets the speed to 1000 Mbps and enables link negotiation for flow-control parameters and remote fault information. The "speed nonegotiate" command disables link negotiation.

So if you want negotiation, it is as simple as other commands,

"no speed nonegotiate" command.

http://www.cisco.com/en/US/products/ps6845/products_configuration_guide_chapter09186a00806e9f38.html#wp1040549

Rate if it does,

Rgs

rkcontrol · ‎04-29-2007

Thanks,

The only option was NO SPEED command it solved the problem.

Rgds

Raj

sellersmj · ‎04-30-2007