04-28-2007 11:50 PM - edited 03-05-2019 03:44 PM
Hi all,
1. Why do we need to configure flowcontrol on interfaces.
2. Whenever we enable or disable flowcontrol y do we get the output as shown below, and y is it not removed from the config once the No command issued.
interface GigabitEthernet7/4 (both r on)
flowcontrol receive on
interface GigabitEthernet7/4 (both r off)
flowcontrol receive off
flowcontrol send desired
Thanks
Raj
05-01-2007 08:49 PM
Hi all,
Can any one help on the above sub.
Thanks,
Raj
05-02-2007 12:57 AM
Raj,
The ports on both ends of a Gigabit Ethernet link must have the same setting. Please visit the link below to clear your concept about why we use flow control.
HTH
Regards,
05-05-2007 09:13 PM
Thanks jamil,
the first part of my question is answered but i could not get the answer for the 2nd part.
Thanks for the link,
Rgds,
Raj
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide