04-28-2007 11:50 PM - edited 03-05-2019 03:44 PM
Hi all,
1. Why do we need to configure flowcontrol on interfaces.
2. Whenever we enable or disable flowcontrol y do we get the output as shown below, and y is it not removed from the config once the No command issued.
interface GigabitEthernet7/4 (both r on)
flowcontrol receive on
interface GigabitEthernet7/4 (both r off)
flowcontrol receive off
flowcontrol send desired
Thanks
Raj
05-01-2007 08:49 PM
Hi all,
Can any one help on the above sub.
Thanks,
Raj
05-02-2007 12:57 AM
Raj,
The ports on both ends of a Gigabit Ethernet link must have the same setting. Please visit the link below to clear your concept about why we use flow control.
HTH
Regards,
05-05-2007 09:13 PM
Thanks jamil,
the first part of my question is answered but i could not get the answer for the 2nd part.
Thanks for the link,
Rgds,
Raj
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: