Netman Question

Unanswered Question
Apr 30th, 2007

In version 2.1 LMS had 2 ways of looking at the connectivity of switches on the network. One was the "Reachability dashboard" and the other I think was " 24 hr availability report". Is there anything similar in version 2.6 ? If I remember correctly each switch had a visual indication, Red down arrow if it wasn't reachable, and green up arrow if it was.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Joe Clarke Mon, 04/30/2007 - 11:07

Availability and reachability were removed in LMS 2.5+. There is an add-on to LMS scheduled to ship this summer that will add MRTG-like capabilities to LMS 3.0. This will allow you to do some of the availability tasks that RME 3.x provided.

For now, DFM does provide fault information related to device reachability (though not in the same format that RME did in the past). You can use the Alerts and Activities Display under DFM to see if a device becomes unreachable.


This Discussion