As mentioned in my original post, I originally attempted to enter the logging event link-status command on the 4948 with no luck.
RouterA(config)#logging ?
Hostname or A.B.C.D IP address of the logging host
buffered Set buffered logging parameters
cns-events Set CNS Event logging level
console Set console logging parameters
count Count every log message and timestamp last occurance
exception Limit size of exception flush output
facility Facility parameter for syslog messages
history Configure syslog history table
host Set syslog server IP address and parameters
monitor Set terminal line (monitor) logging parameters
on Enable logging to all supported destinations
rate-limit Set messages per second limit
source-interface Specify interface for source address in logging transactions
trap Set syslog server logging level
Nor is it a hidden command..
RouterA(config)#logging event link-status
Translating "event"
^
% Invalid input detected at '^' marker.
